Friday, November 20, 2015

Instrumenting MicroPython code using GPIOs

When working with MicroPython I often find that I want to instrument things (like ISR routines) so I get some detailed timing information. So I thought I would document the process I use.

Initialize the Pins

I typically use pins X1, X2, X3, and X4, because they happen to correspond to CPU pins A0, A1, A2, and A3. The pins need to be initialzed as outputs. A reasonable place to put the initialization code is in main.c, just after the GPIO clocks are initialized (search for ```__GPIOD_CLK_ENABLE```).  The line numbers in the main.c link may be incorrect as main.c may change over time and this blog post may not have been updated.

The following snippet is what I would use to initialize 4 pins:

GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.Mode = GPIO_MODE_OUTPUT_PP;
GPIO_InitStructure.Pull = GPIO_NOPULL;
GPIO_InitStructure.Speed = GPIO_SPEED_HIGH;
GPIO_InitStructure.Alternate = 0;
GPIO_InitStructure.Pin = GPIO_PIN_0 | GPIO_PIN_1 |
                         GPIO_PIN_2 | GPIO_PIN_3;
HAL_GPIO_Init(GPIOA, &GPIO_InitStructure);

main.c already includes enough headers that nothing extra is needed for the above.

Toggle the pins

Let's suppose that I want to instrument the IRQ Handler for UART6. In the stm32_it.c file, we'll need to pull in some header files. So add the following #includes:

#include "py/mphal.h"
#include "pin.h"
#include "genhdr/pins.h"

and now we can toggle a GPIO in the ISR handler like so:

void USART6_IRQHandler(void) {
  GPIO_set_pin(pin_A0.gpio, pin_A0.pin_mask);
  GPIO_clear_pin(pin_A0.gpio, pin_A0.pin_mask);


Here's what a typical capture might look like. This was done using the above code and captured while receiving UART data at 1 Mbit/sec.

Thursday, June 12, 2014

Example of a Solderable Jumper/Switch

This was taken from SparkFun's FTDI Basic Breakout It shows on the backside of the board. You can see it in the schematic like this:
and it shows on the board like this (this is a mirror image since it's showing the backside of the board through the front).

You can use an X-acto knife to cut the trace joining the pads, and easily get the functionality back with a blob of solder.